|
 |
|
Ceramics & Minerals form a wide range of inorganic natural products which require drying as very important operation during manufacture of these specialty products.
The final physical properties shape size and granularmetry of these materials are extremely important as the end use suitability depends on these properties. The dryer selection therefore becomes very critical for the final product property. |
Various grades of Insulators special grades of Alumina, ceramics, Tile slip - wall tile slip and floor tile slip, Soft and hard ferrite, Precipitated- Abrasive- Activated silica, Kaolin, China clay are prepared as finally dispersed slurries before drying in a specially designed Spray Drying System can be offered with upstream slurry preparation and downstream product-handling section along with the main Spray Dryer unit Spray Drying operation is the most ideally suited processed for getting dry product in the powder or granular form.
Sand, Coal, limestone calcium derivatives, mica Activated Earth, aluminum are processed as wet cakes in Rotary, Fluid Bed or Flash Dryers. These are large capacity continuous dryers. The design conditions system configurations, capacities may be different depending up on the specific requirements. |
| |
|
|
